1/4" OD x 1/16" NPT Push to Connect Time delay and WG8/10 fillers and is

and WG8/10 fillers and is approximately 11

The Paddle Vertical Support is made of hard anodized aluminum and is used with all Can Stabilizer Assemblies and is used to hold the stability paddles in place

The End Stop Fixing Block is made of stainless steel and anchors the plastic Bridging End Stop to the canning line's table top on all Evolution Series and Fusion canning systems

The proximity sensor used with all lid dropper cylinders and is responsible for detecting the position of the lid dropper slide during operation

This rebuild kit is for crowner cylinders found on all Legacy M2 systems manufactured before 2019

1/4" OD x 1/16" NPT Push to Connect Time delay and WG8/10 fillers and isThe specially designed packing of this connector provides positive sealing under pressure without the reduced flow common with compression fittings. The KQ2 release collar releases both the chuck and collet to provide a low disconnection force for easy removal of the tubing. Accepts nylon and urethane tubes Applicable for both vacuum and positive pressure applications Release collar allows easy removal of tubing without damaging the tube Maximum